[b]instruction how I run Muppy with persistence and swap in qemu[/b]. Created a file that will be used as persistence save partition in qemu: [code]dd if=/dev/zero of=/media/mark/persistence/ext4_muppy10.img bs=1M count=4096 status=progress sudo mkfs.ext4 -L persistence /media/mark/persistence/ext4_muppy10.img[/code] Started Muppy in Qemu [code]qemu-system-x86_64 -vga virtio -display gtk,gl=on -m 2048 -enable-kvm -cdrom muppy10-amd64.iso -drive file=/media/mark/persistence/ext4_muppy10.img,format=raw,if=virtio[/code] Then in Muppy mounted the drive [code]sudo mount /dev/vda/mnt/vda[/code] And created a textfile /mnt/vda/persistence.conf with this content: [code]/ unionfs [/code] Then shutdown muppy. [code]sudo/sbin/poweroff[/code] Then in build-muppy10.sh I added a new menu entry to grub and built Muppy again: [code]menuentry "Muppy 10 (RAM Mode - Persistent Mode)" { linux /vmlinuz boot=live persistence keyboard-layouts=us quiet splash initrd /initrd.img }[/code] Then started qemu again like above and chose the persistence option. Then rebooted. Now the system uses only 217 MB of memory. I also added a 2 GB swapfile: [code]sudo fallocate -l 2G /run/live/persistence/vda/swapfile sudo chmod 600 /run/live/persistence/vda/swapfile sudo mkswap /run/live/persistence/vda/swapfile sudo swapon /run/live/persistence/vda/swapfile[/code] And to activate swap at startup: [code]sudo nano /etc/rc.local[/code] with content: [code]swapon /run/live/persistence/vda/swapfile[/code]